Вы здесь

Check mode procedure

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode.

 

NOTICE:
 
All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the power switch is turned from on (IG) to on (ACC) or off while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.
CHECK MODE PROCEDURE


 

Check mode procedure 2ZR-FXE ENGINE CONTROL / Lexus CT200h / ZWA10
  1. Check and ensure the following conditions:
     

    1. Auxiliary battery voltage 11 V or higher.

    2. Accelerator pedal fully released.

    3. Push the P position switch.

    4. A/C switch off.

     

  2. Turn the power switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the power switch on (IG).

  5. Turn the tester on.

  6. Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.

  7. Switch the ECM from normal mode to check mode.

  8. Make sure that the MIL flashes as shown in the illustration.

  9. Turn the power switch on (READY).

  10. Make sure that the MIL turns off.

  11. Simulate that the conditions of the malfunction described by the customer.

  12. Check DTCs and freeze frame data using the tester.