Вы здесь

Freeze frame data

DESCRIPTION
  1. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

     

    HINT:
     
    If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.

     


  1. Freeze frame data 2ZR-FXE ENGINE CONTROL / Lexus CT200h / ZWA10
    The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the intelligent tester, five separate sets of freeze frame data, including the data values at the time when the DTC was set, can be checked.
    1. 3 data sets before the DTC was set.
    2. 1 data set when the DTC was set.
    3. 1 data set after the DTC was set.
    1. These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.

 

PENDING FREEZE FRAME DATA

 

HINT:
 
Pending freeze frame data is stored when a 2 trip DTC is first detected during the first trip.

 

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus: Powertrain / Engine and ECT / DTC.





  5.  
  6.  
  7. Select a DTC in order to display its pending freeze frame data.

     

    HINT:
     
    1. Pending freeze frame data is cleared when any of the following occurs.
      1. Using the intelligent tester, the DTCs cleared.
      1. The cable is disconnected from the negative (-) auxiliary battery terminal.
      1. 40 trips with the engine fully warmed up have been performed after returning to normal. (Pending freeze frame data will not be cleared by only returning the system to normal.)
    2. With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new one of the newly detected DTC in the next trip.

     


    Freeze frame data 2ZR-FXE ENGINE CONTROL / Lexus CT200h / ZWA10
     

    Freeze frame data 2ZR-FXE ENGINE CONTROL / Lexus CT200h / ZWA10
     

     

 

LIST OF FREEZE FRAME DATA

Refer to "Data List / Active Test" .